Static Voltage Stabilizer, Stable And Reliable

Static Voltage Stabilizer should be used in a ventilated and dry place indoors. Its use conditions are strict. The installation site should be free of gas, steam, chemical deposition, dust, greasy dirt and other explosive and corrosive media that seriously affect the insulation performance of the voltage stabilizer, and there should be no severe vibration and turbulence.

The static voltage stabilizer should be handled with care when arriving at the installation site. The voltage stabilizer should always be in a vertical upward state and must not be subjected to wind, snow, ice, and hail.

Before debugging and installing the static voltage stabilizer, it is necessary to check that all parts of the equipment should be intact, the fixings should be firm and reliable, and confirm again whether the voltage in the use occasion is consistent with the voltage of the voltage stabilizer. This equipment is a three-phase four-wire system with a phase-splitting adjustment method. The reliability requirements of the neutral (neutral) connection of the system are high, and the contact resistance of the neutral (neutral) connection should be reduced as much as possible.

This equipment must be well connected to the ground, and the ground wire cannot be used together with the repeated grounding wire (neutral wire and the side of the ground wire) of the power system to ensure safety and improve anti-interference performance.

Precautions for use:

1. Ambient temperature: -15℃-+40℃;

2. Altitude not exceeding 2000m;

3. Relative humidity <90%;

4. Please use enough wires;

5. The installation site should be free of gases, vapors, chemical deposits, dust, dirt, explosive and corrosive media that may seriously affect electrical insulation;

6. The input voltage must comply with the product input voltage range;

7. Install in a dry and ventilated place;